Debugging Dial Modem on Cisco 831
Run these commands: Code: debug dialer debug chat debug modem debug ppp negotiation term mon If possible, create an access list to a host and route that host to the dialer interface. Therefore, when...
View ArticleCisco DHCP Sites – Changing DHCP Server IP Address
As a reminder to all: There is a known issue with Cisco’s that are installed at site’s that have DHCP ISP service. This is not just particular to EZ Corp, it is with all of our Cisco sites. The...
View ArticleCisco IP Proxy-ARP Problem
This occurs when the Cisco proxies ARP based on devices connected on its interfaces. In other words, if the Cisco detects an ARP request device on the LAN, it will proxy (act on behalf of) for that...
View ArticleClik here to view.
Cisco Bypass Startup config (Do not use on live routers)
If you need to restore a router so you can reuse it again but you do not have the enable secret password, follow these steps to wipe the routers config.1) plug a console cable into the router from your...
View ArticleClik here to view.
Restoring a Cisco 831 from ROMMON
This process can be used when a Cisco 831 keeps booting up into ROMMON mode.Here is an example:The router cannot boot up because the image file has become corrupted. Notice the errrors on the lines...
View ArticleDefaulting a Cisco without the "enable" password (Cisco 1700 Series)
***This has been tested on the 1700 Series only at this time***If a Cisco has an enable password that is unknown you can default the cisco by interrupting the boot process if the break command is...
View ArticleHow To Set The Clock In A Cisco
clock set hh:mm:ss <1-31> MONTH <1993-2035>Actual commandclock set 08:38:00 5 Dec 2005wr mem The post How To Set The Clock In A Cisco appeared first on Beyond web Logs.
View ArticleVPN Hub config with GRE Tunnel and Loopback Interface
** Hub site VPN configuration with GRE Tunnel & Loopback Interface**** This config is built out for 4 spoke locations **(change the portions listed in bold to match desired customer...
View ArticleVPN Spoke Config with GRE Tunnel and Loopback Interface
** Spoke site VPN configuration with GRE Tunnel & Loopback Interface**(change the portions listed in bold to match desired customer configuration)crypto isakmp policy 1encr 3des authentication...
View ArticleBasic Netscreen / Juniper Commands
Below is compiled list of common commands used in support of the Juniper routers. Some of the commands are usable in both 5GT and SSG5, while other commands may vary between the device models. Behind...
View Article